PRODUCT OVERVIEW:

Our Viper Coil Coating is the same formulation we supply to factory OEM’S and custom coil manufacturers. It is the toughest and longest lasting coating you will ever use. Bonds to all metal surfaces and withstands temperatures to 400F (205C). The aerosol injector provides a flat vertical spray pattern for reaching deep into the coil body. In field application, simply apply a single coat to the front and back of the coil. There will be no significant loss of heat transfer when used as directed. Protects coils from salt water and many other chemically corrosive environments. Viper Coil Coating is a solvent borne clear coating that meets all State and Federal VOC regulations.

• Certified – Kosher and meets all State and Federal VOC regulations 
• OEM – Used by OEM’s worldwide
• Tested – 4300 hours at 60°c (10% Salt immersion)
• Permanent Corrosion Protection – Epoxy Resin coating for extreme weather, salt and chemical environments. 
• Fast Drying – Perfect for on site applications.

COMPETITIVE POINTS OF DIFFERENCE:

Viper Coil Coating is a clear, solvent-borne thin film epoxy resin that will bond to all metals and has continuous temperature rating of 205°C. The product will air-dry under normal conditions to completely set in less than 30 minutes. One single application is all that is necessary to protect coils, fins and other metals from salt water, acids, caustics, oxidations and corrosive environments.

APPLICTIONS:

A single coat to the front and back of the coil is all that is necessary for total corrosion protection. Start at the top corner of the coil and work horizontally.

DIRECTIONS:

1. Turn off or disconnect all power from the system.
2. Clean coil with Viper Brite to remove all surface oxidation, rinse and allow surface to dry.
3. Always wear protective gloves, goggles, and clothing. Use in well ventilated areas.
4. Hold the can a few inches away, apply a single coat to the front and back of the coil and all metal parts.
5. Wait 30-60 minutes for product to dry. A full cure may take longer depending on weather conditions.
6. Place system back into operation, all done!

FRIDGEY FACTS:

• Heat transfer loss is less than 0.15%. Apply as a single coat, 0.5mm to 1.5mm thickness as directed.
   
• Viper Coil Coating has a high product-to-propellant ratio compared to its many competitors. The product ratio is 92% product and 8% propellant. This instantly provides greater surface coverage. Typically, one can of Viper Coil Coating
   will service the entire coil surface area of a 30kw condensing unit.
   
• You may pay a little more for Viper Coil Coating than competitive products because Viper Coil Coating has the highest product to propellant ratio and is solvent based, not water based. This means that Viper Coil Coating will bond to base metals that are not entirely free of corrosion or oxidation with a fast drying time, therefore no softening or blistering of the coating will occur during application.
   
• Used worldwide by OEM’s.